How to Use:

SURFACE PREPARATION 
1. Mask-off surrounding areas with tape to protect from overspray (not a must, but best practices).
2. Prepare the surface by cleaning dust, dirt, grease, other coatings, etc. Fine sandpaper, or fine scuff
pad may be used to scuff the clearcoat (but not necessary to achieve a good bond).  Whatever contaminants are on the wheel will be locked in by
the coating.
3. Wipe thoroughly with a good panel prep and let dry. 

APPLICATION
1. Pre-valved spray can that comes with DS1200 Kit is air powered (Valenti System), not an aerosol.  The below application is recommended if just the face of the wheel is being coated.  (HVLP instructions below for pontoons, heavy equipment, wheels off, engine parts, larger areas)

• Pour coating liquid into sprayer can
• Do not shake and hold can straight and parallel throughout spray process to not lose air
• Holding Steadily, prime sprayer in fender wheel well to get a good spray pattern before spraying wheel
• Have a towel soaked with Panel Prep in case spray process creates any runs. Wipe any runs within 1 minute of spraying and respray as necessary.
• For best results, hold 1 to 2 inches from surface using an even, sweeping motion. Start while the spray is pointed away from the object and then move toward the surface to be coated. Overlap parallel layers slightly, Exactly like spraying clear.
• Apply 1 light coat, followed by 2-3 or more medium wet coats to build desired coating thickness. Allow coating to dry 1 minute between each coat.  Build the surface as opposed to a heavy spray.

HVLP Sprayer Application

• Utilize gravity-fed HVLP touchup gun for application on larger areas (Pontoons).
• This process too, the best results are 1" to 2" from surface for best spray and results. (Again, just like spraying clear)
• Use 1.0 to 1.2 fine tip and coating will spray like clear.
• Less is more, do not put on too heavy and have a soaked towel ready with Panel Prep until you get a comfortable spray.
• DO NOT USE AN AIRBRUSH (product is too viscous(THICK))

TIPS

• Allow 1 minute between coats
• 30 minutes to tack-free finish
• 48 hours for full cure

CLEAN-UP

1. After use, clear spray nozzle by inverting can and spray until clear gas comes out.
2. If spray nozzle becomes clogged, clean and rinse with solvent

Duraslic Recommended: Ready to Use.
SNS Customers: Ready to Use.

• Ceramic Coating
• Post-Paint Correction 5-Year Coating
• Final Protection Step
• Vehicle Protection