Soaps & Presoaks
Learn More About
Soaps & Presoaks
Every car wash soap here cleans. What separates them is pH, what they leave behind on the paint, and the equipment they are built for. Presoaks go on first to loosen road film, bugs, and mud before anything touches the surface, and soaps do the wash. Most are concentrated Stinger Chemical formulas, so pick by the job, then set your ratio with the dilution calculator.
How to Choose
Prep before a coating, PPF, or wrap: Lemonlicious 518. pH neutral and free-rinsing, so the surface is ready for the next step.
Maintenance washes on coated vehicles: Ceramic Shampoo 715. Leaves a semi-durable SiO2 layer that keeps water beading.
Fleets, RVs, and trailers you cannot towel dry: Ultimate Wash-N-Wax 714. Its sealant layer makes water sheet off instead of drying into spots.
Everyday foam cannon washing: Bubblicious 704 or Cherry Suds 703. Thick, clinging foam, free of silicone, ammonia, and bleach.
Trucks, tractors, and ag equipment: Body, Tire & Wheel 519. High pH presoak and body soap in one, built to lift mud and road film with little scrubbing.
Aluminum, pontoons, and marine build-up: DS-1000 Low pH Presoak 517. Acid presoak that brightens aluminum and cuts road salt.
No water available: Waterless Wash-N-Wax 700. Wipe on with a wet microfiber, buff off dry. Useful when lines are frozen or shut off.
Frequently Asked Questions
Which car wash soap should I use before a ceramic coating?
A pH-neutral soap with nothing added, like Lemonlicious 518. Skip wash-and-wax and ceramic soaps for prep: they deposit a layer on purpose, and a coating, film, or wrap needs to bond to bare clear coat.
What is the difference between Wash-N-Wax and Ultimate Wash-N-Wax?
Ultimate Wash-N-Wax 714 carries more sealant and is aimed at vehicles too large to hand dry, where sheeting water prevents spots. Standard Wash-N-Wax 705 is the everyday version for vehicles you will dry anyway.
Should I use an acid or alkaline presoak?
Alkaline (high pH) presoaks like Body, Tire & Wheel and Purple Presoak cut road film, grease, and mud. Acid (low pH) presoaks like DS-1000 brighten aluminum and remove mineral and marine build-up. Never mix acid and alkaline products in the same tank, bottle, or sprayer.
Why does my foam cannon make thin, watery foam?
Usually too little soap in the reservoir, hard water, or a pressure washer under about 1.5 GPM. A clogged cannon filter is the other common cause, especially with wax soaps, so flush the cannon with clean water after each use.

