Long Cone for the Twister Blow Gun

This is the replacement long cone built specifically for the full-size Stinger Twister Blow Gun. The cone seats around the rotation assembly and shapes the spinning air into the directed vortex column the tool is built on. It is also the part that absorbs everything the tool runs into: dropped on concrete, knocked against seat rails and door sills, and scoured constantly by the debris it throws. Cones are consumable by design so the motor assembly, trigger, and body are not. When yours cracks, chips, or wears out of round, a replacement returns the gun to full output for a fraction of what a new tool costs.

The long cone fits the Twister Blow Gun only. The Twister Mini and Twister Complete take the short cone instead, and the two lengths are not interchangeable. Check which tool you are ordering for before you buy. If you run the Blow Gun daily, a spare on the shelf turns a cracked cone into a two-minute fix instead of a gun sitting idle. Browse the full Stinger Chemical lineup.

What Makes it Great:

🎯 Built for the Full-Size Blow Gun: The correct cone length for the pistol-grip Twister Blow Gun, so there is no cross-referencing between the two cones offered.

🌪️ Shapes the Vortex Column: Directs spinning air into the twisting pattern that lifts embedded debris out of carpet and upholstery instead of pushing it around.

🛡️ Takes the Abuse So the Internals Do Not: The cone sits at the working end and absorbs the impacts and abrasion that would otherwise reach the rotation assembly.

⏱️ Keeps a Daily-Use Tool Running: The Blow Gun is the volume tool in the Twister line, so its cone sees the most hours. A spare keeps it in rotation.

Frequently Asked Questions

Which Twister tool does the long cone fit?

The full-size Twister Blow Gun, the pistol-grip model. It is made specifically for that tool.

Can I use a long cone on the Twister Mini or Complete?

No. Those two take the short cone. The lengths are not interchangeable, so ordering the wrong one means a cone that will not seat properly.

Why are there two different cone lengths?

The cone is matched to the tool it mounts on. The full-size Blow Gun is a larger body than the Mini and the Complete, so it takes the longer cone. Match the cone to your tool rather than to the job you are doing.

How do I tell if the cone is worn out or just dirty?

Clean it first and look at the shape. Dirt washes off. Wear shows up as cracks, chipped edges, a rim that is no longer round, or a surface that has gone rough and thin. If the geometry has changed, cleaning will not bring the airflow pattern back.

Does a damaged cone actually hurt cleaning performance?

Yes. The tool will still blow air with a cracked or out-of-round cone, which is why the problem often goes unnoticed. What you lose is the tight vortex pattern, so debris gets pushed around the surface instead of lifted out of it.